RYO - Trig Xpander - DIY Full Kit

Add to Cart:

65,00 €
incl. 20% VAT
plus shipping and handling

Availability:

in stock, immediately available

  • Model:
    [RYOTRGXPNDRKIT]
  • Manufacturer: RYO - Ljunggren Audio



This will give your VC Sequencer 8 individual outputs for each step outputting either a trigger or a gate, selectable with a jumper on the pcb, and a 9th output that gives you a trigger for each step progression.

Also on board is a trimmer for setting the trigger length to your liking (ca 1-20 ms). Usually you wan't to set this as low as possible to reach higher rates. Different trig lengths can give a different sound from pinging filters or striking lowpassgates. Some vintage gear also require longer trigs. The gates are high for the full duration of each step.

The outputs are diode isolated, this allows for passive mixing of the outputs using a passive multiple/stackcable/IV cable, or a switched multiple/OR combiner such as the Doepfer A-182 or Low-Gain Short Bus.

The kit comes supplied with two PCBs (one with a v-cut that you break into two), front panel (PCB material), component kit, power and expansion cables and mounting screws. Solder and tools are not supplied.
 
Note! Building these DIY kits happens on your own risk. We can't do support or give a guarantee for correct function, because that depends on your own skills. Be responsible and check the building instructions before you buy. Thank you! 


Customers who bought this product also purchased...


© 2015-2018 Raw Voltage        Programming: webchills        Shopsoftware: Zen Cart
We accept SOFORT Banking, PayPal and Credit Cards